Cancel Submit. How satisfied are you with this comment? In reply to Mettech97's post on June 8, I added this to the article. I have done a clean install of Windows 7 Pro SP1 32bit , on a clean disk. WU fails to identify any update, regardless of how long it runs. After the 1st restart, WU shows 13 updates installed, evidently included on the install disk. WU reports that it has "never" checked nor updated.
It doesn't report any error. Just runs on and on, getting nowhere. Never has downloaded anything. I downloaded: WindowsUpdateAgent It did install itself. Makes no difference. Endlessly searches for updates. Meanwhile I have downloaded these two updates as separately recommended, to prepare for the Rollup: Windows6. Pretty much a complete failure. Any advice? Thanks in advance.
In reply to SteveMatzura's post on August 24, If you're sure that it's stuck, post back and we can work from there. Epsilon Process. In reply to aakkam22's post on August 24, In reply to Epsilon Process's post on August 25, Maybe try after a couple hours? In reply to aakkam22's post on August 25, Yep, waited an hour or so, and it's working again. In reply to averla's post on July 13, Same prolem. And to think that only a year ago it still worked : Windows 7 is dying and we all know it.
RIP Windows 7 : Also, the addon required for the update center int working. This site in other languages x. Log on to your computer using an administrator account, make sure all other users are logged off of the computer, and close all open programs.
If you're using a laptop computer, connect it to an AC electrical outlet and don't unplug or restart the computer during installation. Update any device drivers as necessary. You can do this by using Windows Update or by going to the device manufacturer's website. If you have an uninterruptible power supply UPS connected to your computer, disconnect the connecting serial cable before installing SP2.
The installation automatically attempts to detect devices connected to serial ports, and UPS equipment can cause problems with the detection process. It's fine to leave your computer connected to a UPS for power. Some antivirus software might prevent SP2 from installing, or might slow down the installation. You can try temporarily disabling your antivirus software.
If you do so, be sure that you're aware of the risks involved, and be sure to enable it after the service pack is installed. Make sure you have enough free disk space to install SP2 even though much of that space will be reclaimed after the installation. If your computer is set to automatically install updates, you'll be prompted by Windows Update to install SP2. Follow the instructions on the screen. If you aren't prompted to install SP2, follow these steps:.
Click View available updates. If you are prompted for an administrator password or confirmation, type the password or provide confirmation. Install any updates listed as Recommended or Important , return to the Windows Update page, and then click Check for updates. Follow the instructions on your screen. The computer might restart several times during the installation.
After installation is complete, log on to your computer at the Windows logon prompt. KB Articles: KB Warning: This site requires the use of scripts, which your browser does not currently allow. See how to enable scripts. Select Language:. Additionally, the SP is a roll-up of all previously released updates.
0コメント