Spring roller shade installation

The mechanism does not work as smoothly when your fabric is too thick. This roman shade includes a roller clutch system which. When you mount your shades, make sure you have all of your hardware turned the right way. Next, lift the roller out of the bracket.

I think i spent too much time on that step. Repeat the process as necessary until the shade operates smoothly. Just add fabric to create your own beautiful custom roller shade! Roller blinds, or roller shades as they are sometimes known, use a minimal amount of fabric, lay flat against the window and roll up to let a maximum amount of light into the room. Roller shades are easy to use and are among the simplest of.

When the fabric of the window shade comes off the roller, it can come off the front or back of the roll, just as it can with toilet paper. Take care to adhere the cloth in a straight line onto the roller so the shade will roll up evenly.

Usually, the fabric comes off the back of the blind, but there are a few scenarios where this isn't workable. Line up the top of the fabric shade with the cardboard tube, making sure the roller mechanism is going the right way. Pick a roller shade clutch kit to fit your application and the roller shade fabric of your choi.

This is important because this will allow the material to raise and lower when the roller mechanism is at work. Roller shades are typically made of fabric, vinyl, or screen material.

Clutch mechanisms, and tensioner device replacement. Roller shades can also be motorized and may operate with a remote, wall switch or smart device. Mount brackets using appropriate fasteners. Note: If installing in dry wall, without studs, you will need drywall anchors.

If mounting to side of window frame, you will have to screw through the plastic endcap covers. For spring roller, place right pin end into the right mounting bracket first; then rotates spear end into the left bracket. Your shade is a spring roller, manual lift; not the Draper Flex Shade which operates by a clutch and chain. If for any unforeseen reason, that the Installation Instructions were inadvertently not included within the packaging, the full instructions are available on the Draper, Inc.

Place groove along top of fascia over the endcap brackets and snap into place on front of the mounting brackets. See Figure 2. To lower window shade Grasp center of slat, or pull ring, and pull down. Hesitate, then allow screen to retract very slowly until it locks in place. To raise window shade Grasp center of slat, or pull cord, pull screen down and, while holding, allow for slow retraction into raised position to reduce risk of injury from falling shade.